You are here


Moulding

Colour changing Mood light

The Mood light is a small light that is powered by a 9v battery and controlled by programmable micro controller (Mini – computer), 

Mill, clean and tin all of the RGB boards

Load  RGB program onto chips using ATTINY44 programmer

Solder the pre-programmed chips and surface mount components to the RGB boards

Cut out a square of white acrylic that is 20cm by 20cm on with the laser cutter

Cut out the base and battery assembly

Heat the acrylic in the oven to 400 °Centigrade

Once heated remove from the oven and place on the mould